New 3D Printer Tire Warmers from UK

If anyone is looking for a set of Tyre Warmers give me call.Designed around the range of GRP tyre dimensions (will fit others) but only had new GRP rubber to confirm fit.Installed fit confirmed of the ZH and RG bikes.Key dimension is 8.5mm minimum clearance on the rear wheel diameter.Update: Will not fit the Lightscale One (Thanks Sergio Alves)The front warmer has locations for both 4mm and 5mm sensors which are the most common temperature sensors.Made from Engineering grade high temp PLA which is suitable up to 80°C and is fitted with 16amp tails.I’ve also a 1/5th Bike Stand complete with Controller which is available.Mainland UK delivery included.Will post elsewhere at cost but any custom charges are buyers responsibility. Source: RDP

X-Rider Team Edition Set up tips by Nonaka pilot

The movement of the disc is regulated by inserting a shim,Prevents the disc from tilting too much into resistance during corners.　adjusted so that the disc comes to the center of the caliper with a shim of 0.5 mm on the inside and 0.25 mm on the outside. Also please put return spring inner diameter 0.5 ok, adjust the length by looking at the clearance. Source : Nonaka pilot from Japan

RC Bike meeting in Parma Italy 🇮🇹

It is with great pleasure that I invite you to the RGEvolution meeting 2021 in Fontanellato (Parma) will be three days of good fun on the track all together !!!!! And if we manage on Sunday the classic 2 hours for mixed teams so to have fun !!! Source: RG Evolution

R1 Wurks 10000mAh LiPo battery

R1 Wurks have released this 10,000mAh 130C 2S Graphene battery. Aimed at those needing the absolute highest power, this pack is focussed towards the rc 1/5 moto and drag racing segment where the high capacity equates to lower voltage drop under load. This in turn allows you to cool down and do multiple runs and expect close to consistent times. Source: R1 Wurks [r1wurks.com]

Das EINIBIKE²

Competition motorcycle model powered by a 540 electric motor.The EINIBIKE² is a competition model with an electric drive for RC biking on a scale of 1: 5. In contrast to the many other motorcycle models, the EINIBIKE² focuses on functionality, robustness and ease of maintenance. In order to reduce manufacturing tolerances to a minimum, the bike is mainly made by hand on precision machines, almost all parts were specially made for this bike. The model is delivered pre-assembled, only a few parts need to be added and the screw connections checked.The chassis, as the central and load-bearing element, is made of hardened carbon fiber, which was glued with 2K special adhesive from motor racing. By saving screw connections, weight was specifically reduced and a comparatively higher rigidity was achieved. Mass centralization by placing the components in a very small space also plays an important role here.The front axle is guided